Body Final Fix Prep

When I had the body on last to drill the holes for final fixing i noticed that there was a gap of about 8mm between the rear crossbraces and the body. To get around this i made up some sandwich plates from 40x8mm aluminum flat bar. This was then wurthed and then riveted in place ready.

I also made up two bracing plates to attached the front wheel arches to the front horns. I'll admit to a bit of overkill here opting for some 4mm steel flatbar for this as it will be taking the most pressure in terms of the wind trying to lift the body from the chassis.

Tomorrows the day for final fix!